Page 1 of 1

Representation of the Northern Italy FIR 's

Posted: Wed Dec 21, 2016 3:22 pm
by arp624
Hi all,I want to report a problem with Vroute "online". The representation of the active areas, ie which are covered by ATC, in Northern Italy, is not always correct.
In fact, as you surely know, the Northern Italy includes 2 FIR, one is MILANO (LIMM) and the other is PADOVA (LIPP).
North Italy.png
North Italy.png (222.4 KiB) Viewed 4231 times
In VATSIM, when only the position ATC LIMM_x_CTR (Milano Radar) is active, the controller covers both FIR , Milano and Padova, while when only the position ATC LIPP_x_CTR (Padova Radar) is active, the controller only covers the FIR Padova (LIPP).
Having clarified the above, I note that, in the map of Vroute "online", the representation of active ATC area, into both cases, it is the same, i.e. coverage of both FIR of Milan and Padua is represented.
LIPP_CTR-map.png
LIPP_CTR-map.png (240.21 KiB) Viewed 4231 times
EUROSCOPE-2.png
EUROSCOPE-2.png (57.06 KiB) Viewed 4231 times
This cause intepestive calls from pilots, present in the Milano FIR, to the controller which operates in the FIR of Padua.
Can the Vroute Team correct this anomaly?
Thanks and best regards,
Claudio

Re: Representation of the Northern Italy FIR 's

Posted: Sun Mar 26, 2017 6:47 pm
by Michal Rok
Claudio,

the way it is configured right now, LIPP lights up LIMM+LIPP, while LIMM lights up LIMM only. Should I change that to the following:

LIMM_CTR lights up LIMM+LIPP
LIPP_CTR lights up LIPP only
?


Michal